Oracle XE installation

Installation of Oracle XE and configuration.

• If you downloaded the oracle-xe-univ-10.2.0.1-1.0.i386.rpm executable, you need to enter following command.
# rpm -ivh downloads/oracle-xe-univ-10.2.0.1-1.0.i386.rpm

The installation displays a status of its progress.
• When prompted, run the following command:
# /etc/init.d/oracle-xe configure




Oracle Database 10g Express Edition Configuration
-------------------------------------------------
This will configure on-boot properties of Oracle Database 10g Express
Edition. The following questions will determine whether the database should
be starting upon system boot, the ports it will use, and the passwords that
will be used for database accounts. Press to accept the defaults.
Ctrl-C will abort.

Specify the HTTP port that will be used for Oracle Application Express [8080]:8888

Specify a port that will be used for the database listener [1521]:1521

Specify a password to be used for database accounts. Note that the same
password will be used for SYS and SYSTEM. Oracle recommends the use of
different passwords for each database account. This can be done after
initial configuration:
Do you want Oracle Database 10g Express Edition to be started on boot (y/n) [y]

Starting Oracle Net Listener...Done
Configuring Database...Done
Starting Oracle Database 10g Express Edition Instance...Done
Installation Completed Successfully.
To access the Database Home Page go to http://127.0.0.1:8888/apex

You have now installed Oracle XE on your Linux machine.

For Installation,Documentation and Download you may refer following link .

http://www.oracle.com/technology/software/products/database/xe/files/install.102/b25144/toc.htm#CIHHJEHF